Quality control

Quality is a process, not a final glance

Every order passes through the same inspection flow — from the fabric roll entering the warehouse to the last carton leaving the floor. The standard is written down, applied to small batches and large runs alike, and open to third-party verification.

15,000+
pieces monthly production capacity
2,000
sq m of factory space · 10 lines
15–20
days for bulk production
01

Incoming fabric inspection

Every roll is checked on arrival for color, shrinkage, defects and hand-feel before it is accepted into production.

02

Pre-shrinking & preparation

Fabric is pre-shrunk where the material requires it, so the finished garment holds its size after washing.

03

Precision marker cutting

Computerized marker laying with tight cutting tolerances — checks for stripe and check alignment happen before the knife moves.

04

In-line sewing checks

Stitching, tension and construction are checked on the line, piece by piece, not only at the end.

05

Pressing & finishing

Garments are cleaned, shaped, steam-pressed and stabilized so the fit and drape stay as sampled.

06

Final AQL 2.5/4.0 inspection

Sampling inspection to AQL 2.5 (major) / 4.0 (minor) with zero tolerance for critical defects.

The standard

AQL 2.5 / 4.0, zero critical defects

Final inspection follows the AQL 2.5 / 4.0 sampling standard: 2.5 for major defects and 4.0 for minor defects, applied to a sample drawn from your shipment. Critical defects — anything that makes the garment unsafe or unsellable — carry zero tolerance and are rejected regardless of the sample result.

Close-up of stitching being checked under the needle
What we check

The details buyers actually notice

  • Color consistency against the approved standard
  • Measurements against the approved size spec
  • Stitch quality, seam strength and thread trimming
  • Color fastness and appearance after pressing
  • Labels, care labels and packaging accuracy

Third-party inspection welcome

SGS, Intertek, Bureau Veritas, QIMA or your own QC team can inspect at any stage — before production, during production or before shipment. We also support factory audits.

Arrange an Inspection

For the US market

US labeling basics

If you are selling into the United States, the garment label is part of the product specification. We produce and attach woven or printed labels, care labels, size tags and hang tags to your artwork — and you remain responsible for confirming that the wording and format meet the rules for your product.

16 CFR Part 303

Textile Fiber Products Identification Act

Official rule covering fiber content and country-of-origin labeling. Review the current text on the official eCFR site before finalizing your label.

Read on eCFR.gov

16 CFR Part 423

Care Labeling Rule

Official rule covering care instructions for textile wearing apparel. Review the current text on the official eCFR site before finalizing your label.

Read on eCFR.gov

Reference information only, reviewed November 17, 2026. Rules can change and requirements depend on the product and how it is sold; this is not legal advice and we do not certify compliance. Confirm the current requirements with the official source or your own compliance adviser.

Quality you can verify.

Ask us how we would inspect your next order — we reply within 8 hours.

Discuss Your Standards